Download VC-450LT/RT USER'S MANUAL - RubyTech Deutschland GmbH

RubyTech VC-450LT/RT Managed Industrial VDSL2 CO/CPE Router USER’S MANUAL
4.5 Select “LAN”
The menu below will not be used very often, but when connecting the VC-450LT/RT to a new control PC, one may want to go
through the following steps in order to make the IP address previously set by ifconfig in the console or on some later occasion
one may want to change it again without using the console then the menu below will be helpful. In order to set the IP address,
click on “LAN Settings”.
Select the “LAN”. The menu below includes the sub-menus of LAN Settings, DHCP Client List, LAN Switch Port Setting
and LAN Port Status. A screen is displayed as shown in Figure 4.5.
Figure 4.5 Select LAN
Note:
The settings in the Section 4.5 only need to be performed in order to change LAN settings. Such a change may be necessary
when connecting the VC-450LT/RT to a new control PC and/or in order to turn the IP address changed via a shell command
into a default address for the next restart of the board.
46