Download R&S FPS MSRA User Manual

R&S®FPS MSRA
Configuration
Frequency Settings
"Logarithmic"
Logarithmic scaling (only available for logarithmic units - dB..., and A,
V, Watt)
"Linear Unit"
Linear scaling in the unit of the measured signal
"Linear Percent"
Linear scaling in percentages from 0 to 100
"Absolute"
The labeling of the level lines refers to the absolute value of the reference level (not available for "Linear Percent")
"Relative"
The scaling is in dB, relative to the reference level (only available for
logarithmic units - dB...). The upper line of the grid (reference level) is
always at 0 dB.
Remote command:
DISPlay[:WINDow<n>]:TRACe<t>:Y:SPACing on page 87
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:MODE on page 86
Y-Axis Max
Defines the maximum value of the y-axis in the currently selected diagram in either
direction (in Volts). Thus, the y-axis scale starts at -<Y-Axis Max> and ends at +<YAxis Max>.
The maximum y-axis value depends on the current reference level. If the reference
level is changed, the "Y-Axis Max" value is automatically set to the new reference level
(in V).
This command is only available if the evaluation mode for the I/Q Analyzer is set to "IQ
Vector" or "Real/Imag".
Remote command:
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe] on page 86
7.5 Frequency Settings
Frequency settings for the input signal can be configured via the "Frequency" dialog
box, which is displayed when you do one of the following:
●
Select the FREQ key and then the "Frequency Config" softkey.
●
Select "Frequency" from the "Overview".
User Manual 1176.8574.02 ─ 06
39