Download R&S FPS MSRA User Manual

R&S®FPS MSRA
Measurement Example: Analyzing MSR Signals
3. Press the LEVEL key and set the level to 0 dBm.
4. Press the RF ON/OFF key to switch the RF on.
5. Press the DIAGRAM key and then select "Load Waveform" to load the signal data
from the provided file. From the drive for the USB stick, select the file
C:\R_S\Instr\user\Waveforms\MSRA_GSM_WCDMA_LTE_GSM.wv.
6. Select the "Trigger/Marker" menu and set "Marker1" to "Restart".
Press the ESC key to close the dialog box.
7. Switch the "State" button to "ON" to activate the waveform.
Settings on the R&S FPS
1. Press the PRESET key to preset the R&S FPS.
2. Press the MODE key and select the "Multi-Standard Radio Analyzer" tab. Confirm
the message to switch to MSRA mode.
3. Press the FREQ key and set the "Center Frequency" to 1 GHz.
4. Press the AMPT key and set the reference level to 10 dBm.
5. Press the TRIG key and select "External Trigger 1" to use the external trigger from
the SMx.
6. Press the MEAS CONFIG key, select the "Data Acquisition" softkey and set the
"Sample Rate" to 15 MHz.
Since the R&S FPS is set to continuous sweep mode by default, data acquisition is
started automatically. The spectrum of the stored MSR signal from the file is displayed in the "MSRA Master" tab.
User Manual 1176.8574.02 ─ 06
64