Download User's Manual

RGPS-7244GP / RGPS-7244GP-P User’s Manual
4.1.8.3 Storm Control
Storm control for the switch is configured on this page.
There is a unicast storm rate control, multicast storm rate control, and a broadcast storm rate
control. These only affect flooded frames, i.e. frames with a (VLAN ID, DMAC) pair not present
on the MAC Address table.
The rate is 2^n, where n is equal to or less than 15, or "No Limit". The unit of the rate can be
either pps (packets per second) or kpps (kilopackets per second). The configuration indicates
the permitted packet rate for unicast, multicast, or broadcast traffic across the switch.
(Note: Frames, which are sent to the CPU of the switch are always limited to aproximately 4
kpps. For example, broadcasts in the management VLAN are limited to this rate. The
management VLAN is configured on the IP setup page.)
Label
Description
Frame Type
Status
The settings in a particular row apply to the frame type listed here:
unicast, multicast, or broadcast.
Enable or disable the storm control status for the given frame type.
The rate unit is packet per second (pps), configure the rate as 1, 2, 4,
Rate
8, 16, 32, 64, 128, 256, 512, 1K, 2K, 4K, 8K, 16K, 32K, 64K, 128K,
256K, 512K, or 1024K.
The 1 kpps is actually 1002.1 pps.
ORing Industrial Networking Corp
70