Download User's Manual

Transcript
RGPS-7244GP / RGPS-7244GP-P User’s Manual
"kbps", and it is restricted to 1-1000 when the "Policer Unit" is
"Mbps"
Policer Unit
Shaper Enabled
Configure the unit of measure for the port policer rate as kbps or
Mbps. The default value is "kbps".
Enable or disable the port shaper. The default value is "Disabled".
Configure the rate for the port shaper. The default value is "500".
Shaper Rate
This value is restricted to 500-1000000 when the "Policer Unit" is
"kbps", and it is restricted to 1-1000 when the "Policer Unit" is
"Mbps"
Shaper Unit
Configure the unit of measure for the port shaper rate as kbps or
Mbps. The default value is "kbps".
Click to save changes.
Click to undo any changes made locally and revert to previously
saved values.
4.1.4.3 Port Trunk
4.1.4.3.1 Trunk Configuration
This page is used to configure the Aggregation hash mode and the aggregation group.
Label
Description
Source MAC Address
The Source MAC address can be used to calculate the
destination port for the frame. Check to enable the use of the
Source MAC address, or uncheck to disable. By default, Source
MAC Address is enabled.
Destination MAC
The Destination MAC Address can be used to calculate the
Address
destination port for the frame. Check to enable the use of the
Destination MAC Address, or uncheck to disable. By default,
Destination MAC Address is disabled.
IP Address
The IP address can be used to calculate the destination port for
ORing Industrial Networking Corp
30