Download LCquan 2.7 Quantitative Analysis User Guide

Transcript
3 Exploring the Data
Creating Explore Methods
Peak Limitations
In the Limit Peaks area (Figure 75), you can limit the number of peaks based on user-defined
thresholds (see Table 47).
Figure 75. Limit Peaks area
Y To limit the number of peaks
1. To use only specific peaks, defined by either area or height:
a. In the Select Top Peaks area, select the Enable check box.
b. Select either option: Select By Area or Select By Height.
c. Type the maximum number of peaks to select.
2. To specify a threshold minimum:
a. In the Rel Peak Height Threshold area, select the Enable check box.
b. Specify the percentage of the highest peak to be used for classifying detected peaks.
Table 47. Limit Peaks area parameters (Sheet 1 of 2)
Parameter
Description
Select Top Peaks
Thermo Scientific
Enable
Specifies to use only specific (top) peaks: specific criteria defined
by either area or height.
Select by Area
Specifies peak areas as the only criteria for determining which
peaks to use.
Select by Height
Specifies peak heights as the only criteria for determining which
peaks to use.
LCquan User Guide
131