Download LCquan 2.7 Quantitative Analysis User Guide
Transcript
6 Processing the .raw Files and Reviewing the Analytical Results Reviewing the Calibration Curve and QCs Table 136. User Identification Settings dialog box, Genesis Integration page parameters (Sheet 3 of 3) Parameter Description Tailing Factor Specifies a value for the factor that controls how the LCquan application integrates the tail of a peak. This factor is the maximum ratio of the trailing edge to the leading side of a constrained peak and calculates the retention time of the maximum extent of the right edge of the tailing peak. This option is available only when you select the Constrain Peak Width option. Range: 0.5 to 9.0 Default multiplier: 1.0 (1.0 has no effect) Note You can test the results of the new criteria by clicking Apply or OK. You can apply the new criteria to all files in the Result list by clicking Apply to All. User Identification Settings – Genesis Advanced Use this page (Figure 205) to set up advanced chromatographic parameters. Table 137 lists the parameters for the Genesis Advanced page of the User Identification Settings dialog box. Figure 205. User Identification Settings dialog box showing the Genesis Advanced page 354 LCquan User Guide Thermo Scientific
Related documents
LCquan 2.8 User Guide Version A
LCquan 2.5.6 Quantitative Analysis User Guide
Welch Allyn AED 20 Brochure
Xcalibur 2.1.0–2.3.0 Quantitative Analysis User Guide Version E
701992/701994 Xviewer User`s Manual - Electro
User's Guide - Lindberg & Frisk
Watson TSQ Module 1.0 User Guide Version A
Watson TSQ Module 1.1 User Guide Version A
Xcalibur 2.1–2.3 Creating and Searching Libraries User Guide
Agilent 7696A Echantillonneur WorkBench Guide de démarrage