Download LCquan 2.7 Quantitative Analysis User Guide

Transcript
6
Processing the .raw Files and Reviewing the Analytical Results
Reviewing the Calibration Curve and QCs
Table 136. User Identification Settings dialog box, Genesis Integration page parameters
(Sheet 3 of 3)
Parameter
Description
Tailing Factor
Specifies a value for the factor that controls how the LCquan
application integrates the tail of a peak. This factor is the
maximum ratio of the trailing edge to the leading side of a
constrained peak and calculates the retention time of the
maximum extent of the right edge of the tailing peak. This option
is available only when you select the Constrain Peak Width
option.
Range: 0.5 to 9.0
Default multiplier: 1.0 (1.0 has no effect)
Note You can test the results of the new criteria by clicking Apply or OK. You can apply
the new criteria to all files in the Result list by clicking Apply to All.
User Identification Settings – Genesis Advanced
Use this page (Figure 205) to set up advanced chromatographic parameters. Table 137 lists
the parameters for the Genesis Advanced page of the User Identification Settings dialog box.
Figure 205. User Identification Settings dialog box showing the Genesis Advanced page
354
LCquan User Guide
Thermo Scientific