Download User's Guide

6 To Make Measurements
RIGOL
Measurement Setting
1.
Source Selection
Press Measure  Source to select the desired channel for measurement (CH1
to CH4). The color of the parameter icons under MENU at the left of the screen
will change with the source selected.
2.
Measurement Range
Press Measure  Meas.Range  Meas.Range to select “Screen Region” or
“Cursor Region” for measurement. When “Cursor Region” is selected, two cursor
lines appear on the screen. At this point, press Cursor A and Cursor B and use
to adjust the position of the two cursor lines respectively so as to determine
the measurement range.
3.
Delayed Measurement Setting
Specify the source A and source B in the measurement items “Delay A→B ”
and “Delay A→B ”.
Press Measure  Meas.Setting  Type  “Delay” and then press Source A
and Source B to set the two channel sources (CH1 to CH4) of delayed
measurement respectively.
4.
Phase Measurement Setting
Specify the source A and source B in the measurement items “Phase A→B ”
DS4000 User’s Guide
6-21