1
Download HP 220mx Command Reference Guide
Transcript
Autochanger Error Codes Hardware Error Codes Hardware Error Codes Hardware Errors are reported through the Request Sense Command (03H), (Byte 19, Table 5-6 on page 5-14), the Log Sense Command (4DH), and the Receive Diagnostic Results Command (1CH), (Byte 1, Table 3-30 on page 3-34). If an error is unrecoverable (i.e., something is broken or jammed beyond recovery without manual intervention), the Autochanger will take an additional step of attempting to identify the FRU that is causing the failure. Up to three FRUs will be returned to aide service in replacement priority. NOTE The FRU numbers returned are indicators for the most likely cause of an error, but may not be the actual cause of a problem. Simply changing the FRU listed may or may not fix the associated problem. Table B-7 Hardware Error Codes (medium and large models only) Error Code (hex.) Failure Description 01 ROM checksum error 02 Register error 03 Microprocessor error 04 Controlled area of RAM checksum error 05 RAM test error 06 SCSI chip error 07 Jukebox controller chip error 0F Configuration module failure Appendix B B-19 Autochanger Error Codes A routine that performs a process of elimination for various FRUs runs automatically. It attempts to isolate the error to three or less FRUs. If no error can be found (or if error recovery was made), the unit will return a No Error status. If an error is found, a Hardware Error Code is returned when the command completes.
