1
Download Dell W-IAP103 CLI Reference Guide
Transcript
l2tpv3 session l2tpv3 session <l2tpv3_session_profile> cookie len <len_of_cookie> value <cookie_val> default-l2-specific-sublayer l2tpv3 tunnel <l2tpv3_tunnel_prof_to_associate> tunnel-ip <local_ip_addr_tunnel> mask <tunnel_mask> vlan <tunnel_mgmt_vlan> no… Description This command configures an Layer-2 Tunnel Protocol (L2TP) session profile. Syntax Parameter Description Range Default l2tpv3 session <name> Configures the session profile name. — — cookie len <len_ of_cookie> value <cookie_val> Configures the length and alphanumeric value for the cookie. Length: 4/8 Not set. If cookie length is 4, the cookie value should have exactly 8 hexadecimal characters. If cookie length is 8, the cookie value should have exactly 16 hexadecimal characters default-l2specificsublayer Enables the default l2 specific sublayer in the L2TPV3 session. l2tpv3 tunnel <l2tpv3_tunnel_ prof_to_ associate> Selects the tunnel profile name where the session will be associated. — — tunnel <local_ ip_addr_tunnel> mask <tunnel_ mask> vlan <tunnel_mgmt_ vlan> Configures the local IP address, network mask, and VLAN ID of the tunnel. 2-4094 — no… Removes the configuration. — — Usage Guidelines Use this command to configure the session to carry the L2TP data. Example The following example configures the L2TPv3 session: (Instant AP)(config) # l2tpv3 session test_session (Instant AP)(L2TPv3 Session Profile "test_session")# cookie len 4 value 12345678 144 | l2tpv3 session Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
