1
Download Dell Force10 S4810P Command Line Reference Guide
Transcript
You cannot modify the FIPS mode if SNMPv3 users are already configured and
present in the system. An error message is displayed if you attempt to change the
FIPS mode by using the fips mode enable command in Global Configuration
mode. You can enable or disable FIPS mode only if SNMPv3 users are not
previously set up. Otherwise, you must remove the previously configured users
before you change the FIPS mode.
Example
Dell# snmp-server user privuser v3group v3 encrypted auth md5
9fc53d9d908118b2804fe80e3ba8763d priv aes128
d0452401a8c3ce42804fe80e3ba8763d
Related
Commands
show snmp user — Displays the information configured on each SNMP user name.
snmp-server view
Configure an SNMPv3 view.
S4810
Syntax
snmp-server view view-name oid-tree {included | excluded}
To remove an SNMPv3 view, use the no snmp-server view view-name oidtree {included | excluded} command.
Parameters
view-name
Enter the name of the view (not to exceed 20 characters).
oid-tree
Enter the OID sub tree for the view (not to exceed 20
characters).
included
(OPTIONAL) Enter the keyword included to include the MIB
family in the view.
excluded
(OPTIONAL) Enter the keyword excluded to exclude the
MIB family in the view.
Defaults
none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Simple Network Management Protocol (SNMP) and Syslog
1577
