1
Download Dell Force10 Configuration manual
Transcript
Dell(conf)#do show stack-unit all stack-ports all pfc details | find 0 stack unit 0 stack-port all Admin mode is On Admin is enabled Local is enabled Link Delay 45556 pause quantum 0 Pause Tx pkts, 0 Pause Rx pkts stack unit 1 stack-port all The no-more command displays the output all at once rather than one screen at a time. This is similar to the terminal length command except that the no-more option affects the output of the specified command only. The save command copies the output to a file for future reference. NOTE: You can filter a single command output multiple times. The save option must be the last option entered. For example:Dell# command | grep regular-expression | except regular-expression | grep other-regular-expression | find regular-expression | save. Multiple Users in Configuration Mode Dell Networking OS notifies all users when there are multiple users logged in to CONFIGURATION mode. A warning message indicates the username, type of connection (console or VTY), and in the case of a VTY connection, the IP address of the terminal on which the connection was established. For example: • On the system that telnets into the switch, this message appears: % Warning: The following users are currently configuring the system: User "<username>" on line console0 • On the system that is connected over the console, this message appears: % Warning: User "<username>" on line vty0 "10.11.130.2" is in configuration mode If either of these messages appears, Dell Networking recommends coordinating with the users listed in the message so that you do not unintentionally overwrite each other’s configuration changes. Configuration Fundamentals 43
