1
Download Dell Networking S6000 Command Line Reference Guide
Transcript
show ip cam stack-unit
Display CAM entries for a port-pipe of a stack-unit on a S-Series or Z-Series switch.
S6000
Syntax
Parameters
show ip cam stack-unit {id} [port-set {pipe-number} | vrf vrfname {ip-address mask [longer-prefixes [ecmp-group detail]]}|
ecmp-group {detail | member-info [detail [group-index indexnumber]]}| summary]
id
Enter the stack-unit ID. The unit ID range is from 0 to 7 for
the S6000.
port-set pipenumber
Enter the keyword port-set then the number of the stack
unit’s port-pipe. The unit ID range is from 0 to 0 for the
S6000.
vrf vrf-name
Enter the keyword vrf followed by the name of the VRF to
display CAM entries corresponding to that VRF.
network mask
[longerprefixes [ecmpgroup detail]]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only. You can enter one of the
following keywords to filter results.
ecmp-group
{detail |
member-info
[detail [groupindex indexnumber]]}
summary
Command
Modes
752
•
EXEC
•
EXEC Privilege
•
Enter the keyword longer-prefixes to view routes
with a common prefix.
•
Enter the keyword ecmp-group detail to view the
ECMP group index.
(OPTIONAL) Enter the keyword ecmp-group then one of the
following keywords to filter results.
•
Enter the keyword detail to view the ECMP group
index.
•
Enter the keyword member-info to view the member
information for the ECMP group.
•
Enter the keyword member-info detail to view
detailed ECMP membership and n-hop information.
•
Enter the keyword group-index then the index number
to show ECMP membership per group. The range is from
0 to 1022.
(OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
IPv4 Routing
