Download Dell Networking S5000 Command Line Reference Guide

Transcript
Force10 Resilient Ring Protocol (FRRP)
18
Force10 Resilient Ring Protocol (FRRP) is supported on the S5000 switch.
FRRP is a proprietary protocol for that offers fast convergence in a Layer 2 network without having to run the Spanning
Tree Protocol. The Resilient Ring Protocol is an efficient protocol that transmits a high-speed token across a ring to
verify the link status. All the intelligence is contained in the master node with practically no intelligence required of the
transit mode.
Important Points to Remember
•
FRRP is media- and speed-independent.
•
FRRP is a Dell Networking proprietary protocol that does not interoperate with any other vendor.
•
Spanning Tree must be disabled on both primary and secondary interfaces before Resilient Ring protocol is
enabled.
•
A VLAN configured as the control VLAN for a ring cannot be configured as a control or member VLAN for any
other ring.
•
Member VLANs across multiple rings are not supported in Master nodes.
•
If multiple rings share one or more member VLANs, they cannot share any links between them.
•
Each ring can have only one Master node; all others are Transit nodes.
clear frrp
Clear the FRRP statistics counters.
S5000
Syntax
Parameters
clear frrp [ring-id]
ring-id
Defaults
none
Command Modes
EXEC
Command History
Usage
Information
Version 9.0(1.3)
(Optional) Enter the ring identification number. Range: 1 to 255.
Introduced on the S5000.
Executing this command without the optional ring-id command clears the statistics
counters on all the available rings. FTOS requires a command line confirmation before the
command executes. This commands clears the following counters:
451