Download Canon imagePRESS C800/C700 Quick Reference Guide

Important Safety Instructions
IMPORTANT
Do not install the machine in the following locations
• A location subject to rapid changes in temperature
and humidity
• A location near equipment that generates magnetic
waves or electromagnetic waves
It is recommended that the room be appropriately
ventilated, sufficient to maintain a comfortable
working environment, in areas of machine operation.
In addition, do not install this machine where it
exhausts directly onto a person.
• A location where chemical reactions occur, such as a
laboratory
Do not install the machine in a location where
condensation occurs
• A location exposed to corrosive gas or toxic gas
If the room where the machine is installed is heated
rapidly, or the machine is moved from a cool, dry
location to a hot, humid location, water droplets
(condensation) may form inside the machine. This
may result in paper jams, poor print quality, or a
malfunction. To prevent these problems, wait at
least two hours before using the machine in order to
adapt the machine to the ambient temperature and
humidity.
• A location where the floor may be warped due to
the weight of the machine, such as on a carpet
Avoid poorly ventilated locations
This machine generates a slight amount of ozone
etc. during normal use. Although sensitivity to ozone
etc. may vary, this amount is not harmful. Ozone etc.
may be more noticeable during extended use or long
production runs, especially in poorly ventilated rooms.
Provide Adequate Installation Space
Provide enough space on each side of the machine for unrestricted operation.
4" (100 mm) or more*1
60" (1,524 mm)
69 1/2" (1,765 mm)
31 1/2" (800 mm) or more*2
289 3/8" (7,349 mm)
76 7/8" (1,952 mm)
When the Output Tray-A1, Duplex Color
Image Reader Unit-H1, and Upright
Control Panel-D1 are attached.
When the Two-Knife Booklet Trimmer-A1, Booklet Trimmer-D1, Saddle
Finisher-AM2, Paper Folding Unit-F1, High Capacity Stacker-G1, Perfect
Binder-D1, Professional Puncher Integration Unit-C1, Professional
Puncher-B1, Document Insertion Unit-M1, Duplex Color Image Reader
Unit-H1, Upright Control Panel-D1, and Multi-drawer Paper Deck-B1 are
attached.
*1 Make sure to provide at least 31 1/2" (800 mm) of space if you attach one or more of the following: Paper Folding Unit-F1, Professional
Puncher-B1, Document Insertion Unit-M1, Multi-drawer Paper Deck-B1, Perfect Binder-D1, or High Capacity Stacker-G1.
*2 Make sure to provide at least 4" (100 mm) of space if none of the Paper Folding Unit-F1, Professional Puncher-B1, Document Insertion
Unit-M1, Multi-drawer Paper Deck-B1, Perfect Binder-D1, or High Capacity Stacker-G1 is attached.
7