Download Avaya Using Technician Interface Scripts User's Manual
Transcript
Using Technician Interface Scripts show ping The show ping <option> commands display information about the Bay Networks Ping MIB service, which provides a means for tracking the network availability and response time of IP networks. For information about how to configure the Bay Networks Ping MIB service through Site Manager, see Managing Routers and BNX Platforms. The show ping command supports the following subcommand options: config sourceroutes history version sourceroutes config Displays configuration information about the Ping MIB service: 2-478 IP Address IP addresses that the router is configured to ping. Size Number of bytes of data that the router is configured to send each time it pings an IP address. Retry Number of successive times that the router is configured to repeat a ping of an IP address. Timeout Length of time (in seconds) after which the router is configured to time out an unsuccessful ping of an IP address. Status Status of the ping attempt (for example, initializing, done, busy, or one of a number of error messages). 117380-A Rev. A
Related documents
Avaya Using Technician Interface Scripts User's Manual
Avaya Router Software Version 10.00 Release Notes
Avaya Troubleshooting Routers Troubleshooting
Avaya Troubleshooting Routers Troubleshooting
ASN SERVICE GATEWAY USER MANUAL VERSION V13.0
Cisco Systems WC-293 User's Manual
HP -UX SNAplus2 User's Manual
Kodak A-61097 User's Manual
PQ–MDS–T1 084-00214-2 PMC T1/Slic
MDC-4910 User Manual (Revision 01)
Avaya Router Software 11.00 Release Notes
Avaya Troubleshooting Routers Troubleshooting