Download Avaya BSGx4e CLI Reference Guide

3 Configuration commands
Calls analyser command
call analyzer
Use this command to configure voice quality monitoring.
Syntax
config
jb [static|adpative] min <buffer size> max <buffer size> nom
<level> rtdelay <ms> quality [yes|no] burst [yes|no] delay
[yes|no] rquality <seconds> rburst <seconds> burstmin <ms>
delaymax <ms> qalertclear <seconds> balertclear <seconds>
dalertclear <seconds>
Parameters
Example
NN47928-107
jb static|adaptive
Specify a static or adaptive jitter buffer.
min buffer size
Specify the minimum size of the simulated
jitter buffer. The default is 10.
max buffer size
Specify the maximum size of the simulated
jitter buffer. The default is 60.
nom level
Specify the nominal size of the simulated jitter
buffer. The default is 30.
rtdelay ms
Estimate of round trip delay if no RTCP records
are detected. The default is 60 milliseconds
(ms).
quality yes|no
Enable alarms for low quality R-factor. The
default is yes.
burst yes|no
Enable alarms for excessive bursting. The
default is yes.
delay yes|no
Enable alarms for excessive bursting. The
default is yes.
rquality seconds
Alarm trigger for low quality R-Factor. The
default is 60.
rburst seconds
Alarm trigger for excessive bursting. The
default is 60.
burstmin ms
Minimum alarm trigger for excessive bursting
duration (in ms). The default is 500 ms.
delaymax ms
Maximum alarm trigger for excessive delay (in
ms). The default is 450 ms.
qalertclear seconds
Minimum duration until the low quality alarm
is cleared. The default is 3 seconds.
balertclear seconds
Minimum duration until the excessive bursting
alarm is cleared. The default is 3 seconds.
dalertclear seconds
Minimum duration until the excessive delay
alarm is cleared. The default is 3 seconds.
> config call analyser jb static quality yes burst yes delay
yes rquality 50 rburst 50 minburst 1000 maxdelay 100
29