Download Intermec 073290-001
Transcript
Chapter 4 — Theory of Operation Bus I/F Scanner I/F SDBUF_D7..0 DMA BUFFER FIFO SA25..0 SCAN_DREQ Host CPU I/F DQM3..0 nOE nWE nPWE RDY RD/WR FPGA_CS PCI/HCR_CS ADDR DECODE, RD/WR CTL SCAN_IRQ IRQ CTL IMAGE CAPTURE STATE MACHINE CTL REGs BLUR DETECT, EXPOSURE SENSE DBP COUNT LOGIC GPIO Kypd IO MUX LOGIC SD31..0 DBP_HSYNC Scanner SOS_VSYNC TETH_DBP, SOS I/F TETH_PRESENT ILLUM_LASEN_RTS SPEED_RANGE_GDRD SCAN_FLASH_EN SCAN_TRIG* IMAGER_PIXCLK SCAN_LED SCAN_LED_LOW USER_LED<2:1> DOCK_TRIG* VOL<2:0> GPIO KEY_RET<7:0> HCR_WR2* HCR_WR5* PCI CTL REGs BUS ARBITER BATT_FAULT_IRQ REQ#, GNT# CK30 FPGA Block Diagram-Count Gathering for 1D Scanners The scanner is enabled and controlled from the PXA255 through memorymapped registers in the FPGA and octal register U11 (see the “Using the Scanner Interface Signal Set” table on page 76): • SCAN_PWR_EN* is asserted low to switch 3.3V and 5V power through high-side switches U12 and U13 to scanner connector J3. The scan flex is used to select the voltage appropriate to the installed scanner. The selected voltage is also routed through a loop-back on the flex to provide the appropriate pull-up voltage (SCAN_VCC) for signals from open-collector scanner outputs (like SCAN_TRIG*, DBP_HSYNC, and SOS_VSYNC). Most scanners are powered up only when scanning is commanded, but tethered scanners are powered continuously while the CK30 is on so that their triggers will work. • SCAN_FLASH_EN* is asserted low to enable the scanner and/or start its dither mirror. • ILLUM_LASEN_RTS is asserted low to enable the laser or scanner illumination. • SCAN_TRIG* is set high or low depending on the scanner. This is a general-purpose control line used for spotter beam control, scan speed selection, scanner reset, or tethered scanner auto-detect enable, depending on the installed scanner (See “Using the Scanner Interface Signal Set” on page 76). CK30 Handheld Computer Service Manual 79