Download Accessory Power BlueSYNC MC

Operating Instructions
Connect the BlueSync MC to Power:
Connect the (b) AC plug into a wall outlet and plug the small end into the (7) DC in port.
Find the (5) On/Off switch on the rear of the speaker and switch it to the ON position.
The (4) Power LED indicator will illuminate to indicate power flow.
Pairing your mobile Bluetooth device to the BlueSync MC:
Pairing instructions may differ depending on the device you are using. Please refer to
your device’s user manual for further information.
1- Pairing
a. Make sure that your mobile device is within at least 3 feet of the receiver when
trying to pair and that the BlueSync MC is powered on.
b. Enter pairing mode on the BlueSync MC by pressing and holding the (3) Bluetooth
pairing button for 3 seconds until the (4) Power LED indicator flashes rapidly and
you hear 2 short tones.
c. Access the Bluetooth settings in your mobile device and select SEARCH/SCAN FOR
DEVICES. Your mobile device will begin to search for a Bluetooth Signal.
d. You will see the name “BlueSync MC”appear in the device list. Select it to pair, and
if a password or PIN is needed enter the numbers “0000”.
***You may have to then select BlueSync MC and press “CONNECT”.
e. After a successful connection has been made, you will hear a short tone and the
(4) Power LED indicator will flash every 3 seconds.
2- Toggling between paired devices
a. Toggling allows you to switch between devices that have been paired with the
BlueSync MC.
b. To switch devices, press the (3) Bluetooth pairing button once. Allow 3 seconds
after pressing the (3) Bluetooth pairing button. Press up to 8 times to toggle
through the paired memory. If your device does not connect after toggling, please
refer to the pairing instructions.
c. After a successful connection has been made you will hear a short tone.