Download Intel Pentium B940
Transcript
Processor Configuration Registers 2.18.10 FEDATA_REG—Fault Event Data Register This register specifies the interrupt message data. B/D/F/Type: Address Offset: Reset Value: Access: Bit 2.18.11 Attr 0/2/0/GFXVTBAR 3C–3Fh 00000000h RO, RW Reset Value Description 31:16 RO 0000h Extended Interrupt Message Data (EID) This field is valid only for implementations supporting 32-bit interrupt data fields. Hardware implementations supporting only 16-bit interrupt data treat this field as reserved. 15:0 RW 0000h Interrupt message data (ID) Data value in the interrupt request. Software requirements for programming this register are described in the VTd specification. FEADDR_REG—Fault Event Address Register This register specifies the interrupt message address. B/D/F/Type: Address Offset: Reset Value: Access: Bit 2.18.12 Attr 0/2/0/GFXVTBAR 40–43h 0000_0000h RW, RO Reset Value 31:2 RW 0000_000 0h 1:0 RO 00b Description Message Address (MA) When fault events are enabled, the contents of this register specify the DWORD-aligned address (bits 31:2) for the interrupt request. Software requirements for programming this register are described in the VTd specification. Reserved FEUADDR_REG—Fault Event Upper Address Register This register specifies the interrupt message upper address. This register is treated as reserved by implementations reporting Extended Interrupt Mode (EIM) as not supported in the Extended Capability register. B/D/F/Type: Address Offset: Reset Value: Access: Bit 31:0 Datasheet, Volume 2 Attr RO 0/2/0/GFXVTBAR 44–47h 0000_0000h RO Reset Value Description 0000_000 0h Message Upper Address (MUA) Hardware implementations supporting Extended Interrupt Mode are required to implement this register. Software requirements for programming this register are described in the VTd specification. Hardware implementations not supporting Extended Interrupt Mode may treat this field as reserved. 271