Download Audiocodes Mediant 600

SIP User's Manual
4. ini File Configuration
4.4.12 Analog Telephony Parameters
Note: Analog parameters are applicable only to Mediant 1000.
Table 4-12: Analog Telephony Parameters
ini File Parameter
Prefix2ExtLine
Description
Defines a string prefix (e.g., '9') that when dialed from an FXS port causes
the device's FXS port to play a secondary dial tone and then restart digit
collection.
The valid range is a 1-character string. The default is an empty string.
Note: This parameter is applicable only to Mediant 1000 FXS interfaces.
EnableMOH
Enables the option of using an external audio source, which is connected
to the device's AUDIO connector (on the CPU module). When enabled, the
device uses the incoming audio from this connector instead of playing the
Held Tone defined in the Call Progress Tones (CPT) file.
ƒ
[0] = Disable (default).
ƒ
[1] = Enable.
Note: EnableHold must be set to 1 to enable this feature.
FirstCallRBTId
Defines the index of the first Ringback Tone in the Call Progress Tones
(CPT) file.
The valid range is -1 to 1,000. The default value is -1 (play standard
Ringback tone).
PrecedenceRingingTyp Defines the index of the Precedence Ringing tone in the Call Progress
Tones (CPT) file. This tone is used when CallPriorityMode is set to 1 and a
e
Precedence call is received from the IP side.
The valid range is -1 to 16. The default value is -1 (plays standard Ringing
tone).
FXONumberOfRings
Defines the number of rings before the device's FXO interface answers a
call.
When set to 0, the FXO seizes the line after one ring. When set to 1, the
FXO seizes the line after two rings.
The valid range is 0 to 255. The default is 0 seconds.
Note: If caller ID is enabled, and if the number of rings defined by the
parameter RingsBeforeCallerID is greater than the number of rings defined
by this parameter, the greater value is used.
Version 5.4
355
May 2008