Download Audiocodes Mediant 600

Mediant 1000 & Mediant 600
3.4.1.2
Configuring the Multiple Interface Table
The 'Multiple Interface Table' page allows you to configure up to three logical network
interfaces, each with its own IP address, unique VLAN ID (if enabled), interface name, and
application types (i.e., Control, Media, and/or Operations, Administration, Maintenance and
Provisioning - OAMP) permitted on the interface. In addition, this page provides VLANrelated parameters for enabling VLANs, and for defining the 'Native' VLAN ID (VLAN ID to
which incoming, untagged packets are assigned). For assigning VLAN priorities and
Differentiated Services (DiffServ) for the supported Class of Service (CoS), refer to
''Configuring the QoS Settings'' on page 78.
Notes:
•
Once you access the 'Multiple Interface Table' page, the 'IP Settings'
page is no longer available.
•
You can also configure this table using the ini file table parameter
InterfaceTable (refer to ''Networking Parameters'' on page 296).
¾ To configure the multiple IP interface table, take these 7 steps:
1.
Open the 'IP Settings' page (refer to ''Configuring the IP Settings'' on page 64).
2.
Under the Multiple Interface Settings group, click the right-arrow
Multiple Interface Table; a confirmation message box appears:
button alongside
Figure 3-42: Confirmation Message for Accessing the Multiple Interface Table
3.
Click OK to confirm; the 'Multiple Interface Table' page appears:
Figure 3-43: Interface Table Page
4.
In the 'Add' field, enter the desired index number for the new interface, and then click
Add; the index row is added to the table.
5.
Configure the interface according to the table below.
6.
Click the Apply button; the interface is immediately applied to the device.
7.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
SIP User's Manual
68
Document #: LTRT-83303