Download WiComm-1

Chapter 4. Installation
4.3.2
Checking Wireless LAN Operation
For wireless communication using the WiComm-1, 802.11b/g wireless network should satisfy the followings:
y
y
A PC or equipment equipped with 802.11b/g wireless function to connect the WiComm-1 directly (in Ad-Hoc
mode)
Wireless Access Point (AP) supporting 802.11b/g to connect the WiComm-1 to a wireless network (in
Infrastructure mode)
For wireless network setting, a user should know various data concerned with wireless network.
y
y
y
y
Wireless mode to be used (Infrastructure or Ad-hoc)
SSID of wireless network to be used (service set identifier)
Frequency channel
Wireless security setting value (WEP )
If a user enters the wireless network setting by referring to wireless LAN settings in ‘Chapter 5. Setting via Web’,
the MAC address of the connected Access Point in the Access Point column on the initial Web Access window is
appeared and the signal strength is displayed in Link Quality.
Figure 4-4.
Wireless Status Window
Note
If a user uses a TCP/IP network but a dynamic IP address is not assigned through a Dynamic
Host Configuration Protocol (DHCP), the user should assign a fixed IP address to the
WiComm-1 directly. If the user assigned a subnet address different from that of the PC to be
connected to the WiComm-1, the user should set the sebnet mask and default gateway
addresses.
4-6