Download P1 Rel 1.1 Software Release Notes

Transcript
RN: 4-4
The following replaces information in the P1 Disk and Tape Functions
Manual, Chapter 4, Section 1, starting on page 4--1--1.
_________________________________________________________
This section presents the following information:
D
D
Device error messages and corrective action
Typical problems that can occur when performing disk and tape
operations and possible ways to handle them
Device Error Messages
The following tables list device error messages that may occur when
you are performing a disk activity. Device error messages are preceded
by “DX:” when displayed on the console screen.
Device Error Messages for the Hard Disk
Message
Meaning
Action
Check the SCSI board and cable;
replace the hard drive unit if
necessary.
Hardware Error
A non-recoverable hardware failure in
the hard drive has been detected.
Medium Error
The hard disk probably has bad
magnetic medium.
Replace the hard drive unit.
Drive Not Ready
The hard drive cannot be accessed at
the present time; the hard drive may be
doing a recalibration.
Try the disk activity later.
RS3: Software Release Notes
Changes to RS3ä Manuals