Download iPBridge Installation and Operation Manual

DisplayTraceLogFilter
EmailNotifyAddress
Filters the display of data for specific ports while in
DisplayTraceLog mode.
Default: all all all
set DisplayTraceLogFilter [FC | all] [fp | all] [none |
chkcond | all]
get DisplayTraceLogFilter [FC | all] [fp | all]
Configures notification addresses. Index is a number
between 1 and 5. Full Email address is a fully qualified
Internet Email address, not more than 128 characters
long.
Warning levels
None: no Emails are sent
Critical: only critical severity events engender an
Email
Warning: warnings and critical events precipitate
Email
All: all warnings, critical events and informational
messages warrant an Email.
set EmailNotifyAddress [index] [full email address]
[warning level]
get EmailNotifyAddress <index | all>
DPMTU
Controls the MTU, or maximum transmission unit, used
by the data port.
Default: 1514
set DPMTU [DPn | all] [1514 | 9014]
get DPMTU [DPn | all]
DumpConfiguration
Displays the iPBridge configuration to the ExpressNlAV
Advanced page text box, an available RS-232 or telnet
session.Results may be truncated in the ExpressNAV
readout.
DumpConfiguration
DumpEventLog
Dumps the entire contents of the event log to the
ExpressNlAV Advanced page text box, an available
RS-232 or Telnet session.Results may be truncated in
the ExpressNAV readout.
DumpEventLog
DumpTraceLog
Dumps the entire contents of the Username to the
ExpressNlAV Advanced page text box, an available RS232 or telnet session.
DumpTraceLog
EmailFromAddress
Configures the Email address that the unit uses to
communicate with the Email server. Full Email address is
a fully qualified Internet Email address, not more than 128
characters long.
set EmailFromAddress [full email address]
get EmailFromAddress
EmailNotify
Regulates Email notification. If VLAN is enabled, the
VLAN ID must be provided.
Default: disabled.
set EmailNotify [enabled | disabled] <[DPn] [VLAN ID]>
get EmailNotify
EmailPassword
Configures the password which authenticates the login to
the SMTP Email server. The password must not be more
than 64 characters. A password is not required if the
Email server does not require authentication.
set EmailPassword
SaveConfiguration command required
EmailServerAddress
Configures the address of the server the unit must
contact in order to send out Email notifications.
Default: 0.0.0.0
set EmailServerAddress [IP address]
SaveConfiguration command required
get EmailServerAddress
EmailUsername
Configures the user name which authenticates the login
to the SMTP Email server. The user name must not be
more than 128 characters. A user name is not required if
the Email server does not require authentication.
set EmailUsername [username]
SaveConfiguration command required
get EmailUsername
EthernetSpeed
Regulates the speed of the iPBridge Ethernet port. If
Auto is enabled, the Ethernet speed is negotiated. When
hard set, 100 speed is half duplex.
Default: auto
set EthernetSpeed [DPn | MPn | all] [100 | 1000 | auto]
get EthernetSpeed [DPn | MPn | all]
vi