Download Avaya Aura - Config Guide

Transcript
•
•
EC500 Features
Calls using Avaya one-X Communicator (softphone).
1.2. Support
For technical support for Metaswitch, contact your Metaswitch Networks support representative.
2. Reference Configuration
Figure 1 illustrates the reference configuration used for the DevConnect compliance testing. The
reference configuration is comprised of Avaya Customer Premises Equipment (CPE) located in the
Solution Interoperability Test Lab in Westminster, Colorado. The Avaya CPE location simulates
an enterprise customer site and uses private IP addressing. At the edge of the Avaya CPE location,
an Acme Packet Session Border Controller (SBC) provides Network Address Translation (NAT)
functionality that converts the private IP addressing to public addressing that is passed to
Metaswitch. The “inside” interface of the Acme Packet SBC is connected to a private subnet. The
“outside” interface of the Acme Packet SBC is connected to a Juniper edge router providing access
to the Metaswitch Test Lab network via the public network.
Metaswitch provided a Direct Inward Dial (DID) 10 digit number for use during the testing. The
DID was mapped by Avaya Aura™ Session Manager to an associated Avaya Aura™
Communication Manager extension.
Metaswitch used the domain 208.xxx.xxx.135. The Avaya CPE environment was assigned the
domain avaya.com. See Section 2.1 for more details regarding the domains.
The following components were used in the reference configuration and are discussed in detail in
subsequent sections.
•
•
•
•
Avaya Aura™ Session Manager on a Avaya S8800 Server
Avaya Aura™ System Manager non an Avaya S8800 Server
Avaya Aura™ Communication Manager on an Avaya S8300 Server, with an Avaya G450
Media Gateway
Avaya Aura™ Communication Manager on an Avaya S8800 Server, with an Avaya G430
Media Gateway
Note – This Communication Manager serves as a Feature Server in the reference configuration for
the Avaya 9600 Series SIP Telephones.
SIP phones (requiring advanced calling features) and non-SIP phones configured on the same
Communication Manager is currently not supported. This restriction will be lifted in future
releases of Session Manager and Communication Manager.
•
Avaya 9600 Series IP Telephones (SIP)
MJH; Reviewed:
RRR xx/xx/xxxx
Solution & Interoperability Test Lab Application Notes
©2010 Avaya Inc. All Rights Reserved.
5 of 91
Metaswitch_SM