Download Verilink PRISM 3030 Multiplexer

108
APPENDIX C: MANAGEMENT INFORMATION BASE (MIB) REFERENCE
Table C-3
Object Name
Object ID
User Access Object Description
dsx1Signal
Mode
{ dsx1Config
Entry 11 }
read-write
Get
Set
“‘none’ indicates that no none(1) - this signal mode No action, this parameter
may not be changed.
is the only mode
bits are reserved for
supported.
signalling on this
channel.
‘robbedBit’ indicates that
T1 Robbed Bit
Signalling is in use.
‘bitOriented’ indicates
that E1 Channel
Associated Signalling is
in use.
dsx1Transmit
ClockSource
{ dsx1Config
Entry 12 }
read-write
dsx1Fdl
{ dsx1Config
Entry 13 }
read-write
‘messageOriented’
indicates that Common
Channel Signalling is in
use either on channel 16
of an E1 link or channel
24 of a T1.”
“The source of Tranmit loopTiming(1) - the
Network Timing is set to
Clock.
Network Clock.
‘loopTiming’ indicates
localTiming(2) - the
that the recovered
receive clock is used as Network Timing is set to
Internal Clock.
the transmit clock.
throughTiming(3) - the
‘localTiming’ indicates Network Timing is set to
that a local clock source some other source than
is used.
Network or Interval.
‘throughTiming’
indicates that recovered
receive clock from
another interface is used
as the transmit clock.”
“This bitmap describes Returns a sum of the
the use of the facilities following
data link, and is the sum other(1) - Rem Comm
Channel is active.
of the capabilities:
dsx1Ansi-T1-403(2) - the
‘other’ indicates that a
protocol other than one Network Framing is ESF,
and PRM Enable is
following is used.
Enabled.
‘dsx1Ansi-T1-403’ refers dsx1Att-54016(4) - the
to the FDL exchange
Network Framing is ESF
recommended by ANSI. or Rem Comm Channel is
‘dsx1Att-54016’ refers to active, therefore TR 54016
messaging is active.
ESF FDL exchanges.
dsx1Fdl-none(8) - the
‘dsx1Fdl-none’ indicates Network Framing is D4,
that the device does not and there is no active Rem
use the FDL.”
Comm Channel.
loopTiming(1) - the
Network Timing is set to
Network Clock.
localTiming(2) - the
Network Timing is set to
Internal Clock.
throughTiming(3) - the
Network Timing is set to
Port 2A Timing.
No action, this parameter
may not be changed.