1
Download Cisco Systems 6500 Switch User Manual
Transcript
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands clear spantree portvlancost clear spantree portvlancost To restore the default path cost to a VLAN on a port, use the clear spantree portvlancost command. clear spantree portvlancost mod/port [vlans] Syntax Description Defaults mod/port Number of the module and the port on the module. vlans (Optional) Number of the VLAN; valid values are from 1 to 1000 and from 1025 to 4094. The default path cost is based on port speed; see Table 2-8 and Table 2-9 for default settings. Table 2-8 Default Port Cost—Short Mode Port Speed Default Port Cost 4 Mb 250 10 Mb 100 16 Mb 62 100 Mb 19 155 Mb 14 1 Gb 4 10 Gb 2 Table 2-9 Default Port Cost—Long Mode Port Speed Default Port Cost 100 Kb 200,000,000 1 Mb 20,000,000 10 Mb 2,000,000 100 Mb 200,000 1 Gb 20,000 10 Gb 2,000 100 Gb 200 1 Tb 20 10 Tb 2 Command Types Switch command. Command Modes Privileged. Catalyst 6500 Series Switch Command Reference—Release 8.1 2-126 78-15474-01
