Download Qlogic QME7342 User guide
Transcript
B–SRP Configuration QLogic SRP Configuration Failover Configuration File 1: Failing over from one SRP Initiator port to another In this failover configuration file, the first session (using adapter Port 1) is used to reach the SRP Target Port. If a problem is detected in this session (e.g., the IB cable on port 1 of the adapter is pulled) then the 2nd session (using adapter Port 2) will be used. # service 0: name SRP.T10:0000000000000001 id 0x0000494353535250 session begin card: 0 port: 1 #portGuid: 0x0002c903000010f1 initiatorExtension: 1 targetIOCGuid: 0x00066a01e0000149 targetIOCProfileIdString: "BC2FC in Chassis 0x0000000000000000, Slot 6, Ioc 1" targetPortGid: 0xfe8000000000000000066a01e0000149 targetExtension: 0x0000000000000001 SID: 0x0000494353535250 IOClass: 0xff00 end session begin card: 0 port: 2 #portGuid: 0x0002c903000010f2 initiatorExtension: 1 targetIOCGuid: 0x00066a01e0000149 targetIOCProfileIdString: "BC2FC in Chassis 0x0000000000000000, Slot 6, Ioc 1" targetPortGid: 0xfe8000000000000000066a01e0000149 targetExtension: 0x0000000000000001 SID: 0x0000494353535250 IOClass: 0xff00 end adapter begin B-14 IB0054606-02 A