Download Monogram ZDBT240 Specifications

Transcript
Installation
Instructions
ISTEP 21 LEVEL
ISTEP 41 SLIDE PRODUCT
THE CUTOUT
• Use an a(!justable
wrench to turn the leveling legs
and raise or lower the product.
• A@lst careflllly; the product
should be level and
I)lumb with cabinetr>
and should align with a@_cent
toekick height,
WARNING:
INTO
D,,n,,t i,,ess,,,.e
push against the glass door when moxing or installing
these products.
Pressm'e against the glass door will
ca use damage.
AVERTISSEMENT
: ep,) ,sse
jamais et ne mettezjamais
de pression
sur la porte
en verre quand vous d_placez
ou installez ces
produits.
Toute pression
sur le verre occasionnera
des dolnlnages.
• Carefiflly slide the trait into the opening.
Be careflfl not to entangle
power cord.
• Make certain that the door protrudes
l" bewmd
the surrotmding
cabinets.
• Check again to be sure the trait is level.
Turn Right to Lower
Turn Left to Raise
ISTEP 51 CHANGE THE TOEKICK
• The stainless
ISTEP 31 CONNECT
• Connect
power
receptacle.
• Check to make
to see if interior
cord
sure power
light
POWER
plug to a properly
turns
steel toekick
is secm'ed
to the back
of the product
or inside.
• The toekick has a
cutout on the left
and right
sides.
Rein ove
grotmded
is on by opening
the door
the plug
on the
left side
on.
MoveFill
Plugto
RightSide
and
reinstall
on the
right side. If
VO/I choose to
install the stainless
steel toekick, reinstall
of that toekick.
"_
the plug on the right side
• Install original screws and spacers or screws and
spacers supplied
with the stainless steel toekick,
Install screws through
the spacer standott,
toekick
and into the base as shown.
ISTEP 61 SET TEMPERATURE
CONTROLS
• The temperatm'e controls are preset. Refer to
the Owner's Manual for more information.
Allow 24 horn's for temperatm'e
5
to stabilize.