Download Mitsubishi Electric Q173HCPU Specifications

4 POSITIONING DEDICATED SIGNALS
(7) FIN signal (M4819+20n) ....................................... Command signal
When a M-code is set in a servo program, transit to the next block does not
execute until the FIN signal changes as follows: OFF ON OFF. Positioning
to the next block begins after the FIN signal changes as above.
It is effective, only when the FIN accelaration/deceleration is set and FIN signal
wait function is selected.
Virtual
<K 1000>
Point
1
2
3
4
CPSTART2
Axis
1
Axis
2
Speed
FIN acceleration/
deceleration
ABS-2
Axis
1,
Axis
2,
M-code
ABS-2
Axis
1,
Axis
2,
M-code
ABS-2
Axis
1,
Axis
2,
M-code
ABS-2
Axis
1,
Axis
2,
CPEND
Point
1
M-code
10000
100
200000
200000
10
300000
250000
11
350000
300000
12
400000
400000
WAIT
10
2
11
M-code outputting
signal
(M4019+20n)
FIN signal
(M4819+20n)
Timing Chart for Operation Description
1. When the positioning of point 1 starts, M-code 10 is output
and the M-code outputting signal turns on.
2. FIN signal turns on after performing required processing in the
Motion SFC program. Transition to the next point does not
execute until the FIN signal turns on.
3. When the FIN signal turns on, the M-code outputting signal
turns off.
4. When the FIN signal turns off after the M-code outputting signal
turns off, the positioning to the next point 2 starts.
POINT
(1) The FIN signal and M-code outputting signal are both signal for the FIN signal
wait function.
(2) The FIN signal and M-code outputting signal are valid only when FIN
acceleration/deceleration is designated in the servo program. Otherwise, the
FIN signal wait function is disabled, and the M-code outputting signal does not
turn on.
4 - 37