Download Enterasys SecureStack A2 A2H124-48P Specifications

RMON Command Set
Alarm Group Commands
12.2.3.2
set rmon alarm properties
Use this command to configure an RMON alarm entry, or to create a new alarm entry with an
unused alarm index number.
set rmon alarm properties index [interval interval] [object object] [type
{absolute | delta}] [startup {rising | falling | either}] [rthresh rthresh] [fthresh
fthresh] [revent revent] [fevent fevent] [owner owner]
Syntax Description
index
Specifies an index number for this entry. Maximum
number or entries is 50. Maximum value is 65535.
interval interval
(Optional) Specifies an interval (in seconds) for RMON to
conduct sample monitoring.
object object
(Optional) Specifies a MIB object to be monitored.
NOTE: This parameter is not mandatory for
executing the command, but must be specified
in order to enable the alarm entry configuration.
type absolute | delta (Optional) Specifies the monitoring method as: sampling
the absolute value of the object, or the difference (delta)
between object samples.
startup rising |
falling | either
(Optional) Specifies the type of alarm generated when this
event is first enabled as:
• Rising - Sends alarm when an RMON event reaches a
maximum threshold condition is reached, for example,
more than 30 collisions per second.
• Falling - Sends alarm when RMON event falls below a
minimum threshold condition, for example when the
network is behaving normally again.
• Either - Sends alarm when either a rising or falling
threshold is reached.
rthresh rthresh
(Optional) Specifies a minimum threshold for causing a
rising alarm.
fthresh fthresh
Specifies a maximum threshold for causing a falling
alarm.
revent revent
Specifies the index number of the RMON event to be
triggered when the rising threshold is crossed.
SecureStack A2 Configuration Guide
12-17