Download Comtech EF Data KST-2000B Product specifications

CDM-600 Satellite Modem
Front Panel Operation
6.3.4.3
Revision 7
MN/CDM600.IOM
MONITOR: RX PARAMETERS
RX=PARAMETERS: EbNo=11.4dB
∆F=+11.7kHz
BER=0.0E-9 BUFFER=51%
RX-LEVEL=-43dBm
If the demodulator is locked, this screen shows the following:
6.3.4.4
Eb/No
This shows the value of Eb/No calculated by the demodulator. The value
referred to here is the energy per information bit (Ebi), divided by the noise
spectral density (No).
∆F
The frequency offset of the received carrier, in kHz, with a displayed resolution
of 100 Hz.
BER
This is an estimate of the corrected BER.
BUFFER
(Buffer fill state) This shows the fill state (in percent), of the receive Buffer. After
a reset, it will read 50. A value <50 indicates that the buffer is emptying, and
>50 indicates that it is filling.
RX-LEVEL
A dBm reading indicating the signal level of the desired receive carrier.
MONITOR: AUPC-PARAMS
AUPC-PARAMS: REMOTE EbNo=6.8dB
TRANSMIT POWER INCREASE=1.2dB
The top line displays the value of Remote Eb/No of the demodulator at the distant end of
the satellite link. The Remote Eb/No will display UNLOCK if the remote DEMOD is
unlocked. The bottom line shows how much the AUPC system has increased the output
power. If AUPC is not enabled, the value of TX POWER INCREASE will show as
0.0 dB.
6.3.5
STORE/LOAD
CONFIGURATION: 0 LOAD STORE
'AVAILABLE'
Select LOAD, STORE or EDIT using the [←][→] arrow keys, then press ENTER.
The user can store, load up to 10 different modem configurations, or record the date
and time of stored configurations in the non-volatile memory of the modem. These
configurations can be viewed using the [↑] [↓] arrow keys, and their names edited.
6–39