Download Microcom 400 Operator`s manual
Transcript
Loading Graphic Images Chapter 6 400 Look-up Table dw,dw,dw,dw... ;Offset in bytes, from START2 to the specified character descriptor. The first entry would point to the descriptor of the first character (the space character for example) and the second entry would point to the second character (the ! character for example) and so on. If a character is not decoded , then the word should point to the default character, usually the space character. This table continues for every character in the font. Note: A graphic will only have one character in the font. 400 Character Descriptor dw ;pixels high dw ;pixels wide 400 Character Data db,db,db... ;data for character The rest of the file would be more character descriptor and character data modules. All data from START1 to the end should ne in ASCII-hex format. This encryption takes the most significant nibble of the byte and adds 48 if between 0-9 and 55 if between 10-15. The same process is preformed for the least significant nibble. For example, the byte 108 decimal, or 01101100 in binary would translate to ASCII hex 6C. 60 400 Operators Manual