Download Microcom 400 Operator`s manual
Transcript
Designing Labels Using LDS FO FIELD ORIENTATION This parameter defines the rotation of each field on the label. The point of rotation is determined from the field justification. 0 1 2 3 FJ Chapter 4 0 degrees (normal rotation). 180 degrees (upside-down rotation). 270 degrees (right rotation). 90 degrees (left rotation). FIELD JUSTIFICATION This parameter defines the justification of each field on the label. See Table 6. 0 1 2 3 4 5 Left justified above base-line. Right justified above base-line. Left justified below base-line. Right justified below base-line. Centered above base-line. Centered below base-line. CMX CHARACTER MULTIPLIER X DIRECTION This parameter multiplies each character in the X direction. The valid range is 1 to 8. (Values above 8 are possible but produce poor quality and are slower to process.) CMY CHARACTER MULTIPLIER Y DIRECTION This parameter multiplies each character in the Y direction. The valid range is 1 to 65536. (Values above 8 produce poor print quality and are not recommended. CS CHARACTER SPACING This parameter adjusts the spacing between each character. If this parameter is not used, then the default for the selected character generator (CGN) is used. Multiplying a text string will not multiply the spacing between characters. This element should be used to properly space the characters. TSP TEXT STARTING POSITION This parameter marks the starting position of the character in the text string to be used as data. This is useful for allowing several fields to use sections of the same text string, minimizing the amount of data transmitted. For example, for the text string 0123456789, A TSP of 5 and a CC (character count) of 2 would print 45. See section 5.3.4 for use of this parameter with clock fields. CONSTANT FIELD This field is always defaulted. CONSTANT FIELD This field is always defaulted. 32 400 Operators Manual