Download Selectronic SP Pro Instruction manual

SERVICE | Service and Maintenance
Maintenance of your SP PRO
Very little is required in order to maintain your SP PRO, however following the steps below will ensure
smooth operation of the system.
• Cleaning. Large particles of dirt can be removed with a soft brush or similar implement. Dust can be
removed with a damp cloth. Solvents, abrasives or corrosive chemicals must not be used for cleaning.
• When the fan filter requires cleaning the Attention indicator will illuminate. Check in the NOW tab of the
Data View section to determine what type of service is required.
All other maintenance on your SP PRO should be performed by a Selectronic Accredited Integrator.
Changing Configuration Settings
The following is recommended when adjusting system settings:
• Save existing configuration file
• Change the minimum set of parameters at any one time then check for expected results.
• Save new configuration file.
Doc #OI0003 Part #004122 Rev 12 2013
| 53