Download Seagate ST12550W Technical data

F.1. MACRO{CONSOLE COMMANDS
147
\/W" is a synonym for \/REWIND", provided for backwards compatibility.
ENABLE
Enable various system startup parameters. Provide a list of parameter names separated
by commas.
ENABLE AUTO-BOOT
The AUTO{BOOT startup parameter. If this paramenter is enabled at startup,
after a short delay (see DEFINE AUTO{BOOT{DELAY), the system will attempt
to boot automatically using the defaults set up via the DEFINE BOOT command.
ENABLE BUS-POLL
The BUS{POLL startup parameter. If this parameter is enabled at startup, the
system will poll the bus to determine the hardware conguration.
ENABLE CACHE-TEST
The CACHE{TEST startup parameter. If this parameter is enabled at startup,
the system will perform a diagnostic check of the cache. This parameter must be
enabled to automatically utilize the cache during some memory tests (see TEST
MEMORY).
ENABLE CLEAR-MEMORY
The CLEAR{MEMORY startup parameter. If this parameter is enabled at startup,
the system will test memory, which leaves all of memory with good parity. If
TEST{MEMORY is disabled and CLEAR{MEMORY is enabled, all memory
is cleared at startup. This prevents any latent parity errors from aecting system behavior. Prior to clearing memory, the static memory tests are performed
(see TEST MEMORY/STATIC). If the PAGER{TEST and CACHE{TEST parameters are enabled, then the combined tests are performed (see TEST MEMORY/COMBINED).
ENABLE CONFIGURE-MEMORY
The CONFIGURE{MEMORY startup parameter. If this paremter is enabled
at startup, the system will congure all available memory. Prior to conguring
memory, each memory may also be tested (see TEST{MEMORY) or cleared (see
CLEAR{MEMORY).
ENABLE MASS-STORAGE-CONFIGURATION
The MASS{STORAGE{CONFIGURATION startup parameter. If this parameter
is enabled at startup, the system will report the mass{storage controller device
conguration and start the disks.
ENABLE PAGER-TEST
The PAGER{TEST startup parameter. If this parameter is enabled at startup,
the system will perform a diagnostic check of the pager. This parameter must be
enabled to automatically utilize the pager during some memory tests (see TEST
MEMORY), and when clearing memory (see CLEAR MEMORY). Since the pager
is needed to use the cache during the TEST MEMORY and CLEAR MEMORY
commands, the use of the cache is implicitly disabled when this parameter is
disabled.