Download Seagate ST12550W Technical data

5.3. FILE SYSTEM
53
At this point the new structure has been dened, initialized, and mounted. TOPS{20 is running,
but there are no les on the disk.
If the disk unit is freshly formatted, TOPS{20 will complain that there are no BAT blocks. If this
happens, respond \Yes" and Ret .
? PS unit 0 has no BAT blocks.
Do you want to write a set of prototype BAT blocks? yes
Ret
Error: If certain error conditions occur while TOPS{20 is mounting the structure (a drive is write
protected, for example), the system prints an error message followed by:
?Have the problems mentioned above been corrected yet:
When the problem has been corrected, type \Y" and Ret .
Loading Internet host names]
%%No SETSPD.
TOAD-1 System, TOPS-20 Monitor 7(101212)-6, built Fri 29-September-1995 9:01AM
Enter current date and time:
The message \%%NO SETSPD" means that the system cannot run the Setspd program. This is
expected because you have not yet loaded the Setspd program into the le system. This message
can be printed at any time before the system requests the date and time.
Enter the current date and time in the form mm{dd{yy hhmm and type Ret . The system will
repeat the date back to you and it will request conrmation type \Y" and Ret .
%%No SETSPD.
TOAD-1 System, TOPS-20 Monitor 7(101212)-6, built Fri 29-September-1995 9:01AM
Enter current date and time: 10-6-95 1320 Ret
You have entered Friday, 6-October-1995 1:20PM,
is this correct (Y,N) y
Why reload?
Ret
Before you get a chance to answer the question \Why Reload?", the system will print some pent{up
errors. Again, these relate to les that are absent because the disk has been scrubbed clean.
When the system is done ranting, answer \Why reload?" with \New" and other verbiage, then type
Ret :