Download Vanner RE Series Installation manual

INCORPORATED
RE Installation Manual
F 3 Figure 3-3: Inverter AC Raceway Connections
26
27
Left
Right
L1
N
GND
L2
AC OUT
L1
N
GND
L2
AC IN
29
28
Bottom
Warning
Class 1 Wiring Methods Are To Be Used For Field Wiring
Connections To Terminals Of A Class 2 Circuit. It Is Also Extremely
Important To Observe A Physical Separation Between Class 1 And
Class 2 Circuits. Be Sure To Route Class 1 And Class 2 Wiring
Through Separate Knockouts And Conduits.
Terminal and Component Definitions
This section contains the descriptions of the connectors and
components called out in Figure 3-2 and 3-3.
(22) and (23) DC connections
Connect 24 or 48 volt DC (depending on your RE model)
positive and negative to the inverter’s flat DC terminals with
5/16 cap screws. Use 5/16 ring terminals or compression lugs.
For the RE24-4500 use a #02286-08, JJN-400, 400A fast blow fuse
and 4/0 cable, and for the RE48-4500, use a #02286-03, JJN-200,
200A fast blow fuse. This fuse is required by UL to be within 18
inches of the Battery Terminals on the battery string.
The wiring of your inverter installation should conform to the
National Electric Code (NEC) and any other state or local
codes in effect at the time of installation. These codes have
3-12
Copyright  2001
Vanner Inc.
4282 Reynolds Dr.
Hilliard Ohio 43026
Phone: (614) 771-2718
FAX: 614-771-4904
www.vanner.com
RE-Installation_Manual_Rev01e
RE-4500
Owners Manual
Rev 01e
910157-A