Download Comfort Glow EF5701 Specifications

 4. Use a hobby knife and #11 blade to remove the
covering to expose the slot for the servo horn and mounting
screw locations in the servo cover.
 5. Use a hobby knife with a #11 blade to trim the
covering 1/16-inch (1.5mm) inside the opening for the
aileron servo in the wing. Use a trim seal tool to iron the
covering down around the edges for a finished opening.
22
 6. Repeat steps 4 and 5 to prepare the remaining aileron
servo cover and hinge the remaining aileron.
 7. Check the fit of the aileron servo cover to the wing.
Note that there is a left and right cover as shown in the
following photos. Make sure to select the correct cover for
the wing panel.
 8. Use a pencil and ruler to draw a line on the cover
1/4-inch (6mm) from the edge of the cover. The line is
located on the end of the cover that has the wider area
between the slot and edge of the cover.
 9. Position the servo on the cover so the horn is
centered in the width of the slot. Align the edge of the servo
with the line drawn in the previous step. Use a pencil to mark
the location of the servo mounting tabs.
Hangar 9 Sundowner 36 ARF