Download Comfort Glow EF5701 Specifications

 5. Slide the tube and wing panel into position on
the fuselage. The wing will fit tight against the fuselage
when installed.
 6. Slide the remaining wing panel into position against
the fuselage.
 8. Measure from each wing tip to each stabilizer tip. Position
the stabilizer so both measurements are equal as shown.
A
A
A=A
Important: The stabilizer must be aligned to the wing
as shown in the following steps. Not doing so may
require excessive trim to correct for misalignment,
which can reduce the performance of the model.
 9. Check the alignment of the stabilizer to the wing by
standing back 6–8 feet (2–3 meters). The distance between
the wing and stabilizer must be equal as shown. If not,
lightly sand the opening in the fuselage for the stabilizer to
correct the alignment.
 7. Slide the stabilizer in the slot at the rear of the
fuselage. Position the stabilizer as far forward in the slot as
possible. Check to make sure the stabilizer is centered in the
fuselage as shown below.
Note: The wing does not need to be secured to
the fuselage at this time. It is only being installed
so the position of the stabilizer can be adjusted.
Hangar 9 Sundowner 36 ARF
Check Alignment
7