1
Download Mercury 200 OptiMax DTS Installation manual
Transcript
Notes _______________________ _______________________ _______________________ _______________________ _______________________ _______________________ _______________________ _______________________ 4. There are three methods for activating the priming process. • CDS-Oil Pump Prime in ACTIVE TEST will activate the priming process. • DDT-Oil Pump Prime in SPECIAL FUNCTIONS will activate the priming process. _______________________ _______________________ _______________________ _______________________ • Within the first 10 seconds after the key switch has been turned on, move the remote control handle from neutral into forward gear 3 to 5 times. This will automatically start the priming process. NOTE: It may take a few minutes for the pump to complete the priming process. _______________________ _______________________ Oil Injection Set-Up _______________________ 1. Fill remote oil tank with the recommended oil listed in the Operation and Maintenance Manual. Tighten fill cap. _______________________ _______________________ _______________________ _______________________ _______________________ _______________________ _______________________ _______________________ _______________________ 2. Remove cap and fill engine oil tank with oil. Reinstall the fill cap. _______________________ _______________________ _______________________ _______________________ 90-898305 1-42
