Download MIMAKI TS5-1600AMF Specifications

Troubles for which error messages are displayed
Error message
Cause
Remedy
The printer received some data other
than command data.
Securely connect the interface cable in
position.
Use an interface cable conforming to
the specifications.
Any parameter outside the range of
acceptable numeric values was
received.
Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for service.
∗∗∗∗∗ ERROR 16 ∗∗∗∗∗
MRL COMMAND
An error occurred in the control system.
Transmit data that is compatible with
the command system supported by this
printer.
∗∗∗∗∗ ERROR 20 ∗∗∗∗∗
I/F BOARD 01
An error occurred in the control system.
∗∗∗∗∗ ERROR 20 ∗∗∗∗∗
I/F BOARD 02
An error occurred in the control system.
∗∗∗∗∗ ERROR 20 ∗∗∗∗∗
I/F BOARD 03
An error occurred in the control system.
Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for service.
∗∗∗∗∗ ERROR 20 ∗∗∗∗∗
I/F BOARD 04
An error occurred in the control system.
∗∗∗∗∗ ERROR 10 ∗∗∗∗∗
COMMAND ERROR
∗∗∗∗∗ ERROR 11 ∗∗∗∗∗
PARAMETER ERROR
∗∗∗∗∗ ERROR 21 ∗∗∗∗∗
I/F NONE
∗∗∗∗∗ ERROR 23 ∗∗∗∗∗
HOST I/F
∗∗∗∗∗ ERROR 24 ∗∗∗∗∗
I/F INITIAL
∗∗∗∗∗ ERROR 25 ∗∗∗∗∗
FULL-SPEED
An error occurred in the control system.
Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for service.
Timeout error occurred during communication between the host computer
and the interface board for IEEE-1394
connection.
Check that the cable is securely connected to the host computer and interface board. Also, check to see if any
error has occurred on the host computer.
An error occurred in the control system.
Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for service.
An error occurred in communication
between the host computer and the
interface board for USB2.0 connection.
(Full-Speed mode connection)
Check that the host PC supports the
USB2.0 interface.
(Communication can be resumed without changing any setting. However, it
is recommend to use the connection in
High-Speed mode.)
5-19