Download Bryant TSTATBBN2S01-C Unit installation

GENERAL INFORMATION
Model Nomenclature
1
2
3
4
5
6
7
8
9
10
11
12
5 0 Y B V 0 3 6 L L A 3 5 1
SERIES:
SIZE:
YBV = VERTICAL UPFLOW TWIN
036
042
048
060
072
PACKAGING:
1 = SINGLE PACK (DOMESTIC)
REVISION LEVEL:
5 = CURRENT REVISION
AIR FLOW CONFIGURATION:
OPTION RETURN
L
R
LEFT
RIGHT
DISCHARGE
FILTER
TOP
TOP
1.000"
1.000"
CONTROLS:
L = CXM W/ICM
VOLTAGE:
3 = 208V, 230V/1PH/60Hz
HEAT EXCHANGER OPTIONS:
A = COPPER WATER COIL, E-COATED AIR COIL
B = COPPER WATER COIL,
HOT WATER GENERATOR, E-COATED AIR COIL
J = CUPRO-NICKEL WATER COIL, E-COATED AIR COIL
K = CUPRO-NICKEL WATER COIL,
HOT WATER GENERATOR, E-COATED AIR COIL
Rev.: 04/18/04D
Inspection
Upon receipt of the equipment, carefully check the
shipment against the bill of lading. Make sure all units
have been received. Inspect the carton or crating of
each unit, and inspect each unit for damage. Assure
the carrier makes proper notation of any shortages or
damage on all copies of the freight bill and he completes
a common carrier inspection report. Concealed damage
not discovered during unloading must be reported to the
carrier within 15 days of receipt of shipment. If not filed
within 15 days, the freight company can deny the claim
without recourse. Note: It is the responsibility of the
purchaser to file all necessary claims with the carrier.
Notify the Customer Service of all damage within fifteen
(15) days of shipment.
Introduction
GT-X Geothermal Heat Pump units are typically
installed in a floor level closet, basement, or in a small
mechanical room. The installation site chosen for these
units must allow adequate clearance for maintenance
and servicing of the unit without its removal from the
installation location.
Storage
CAUTION: DO NOT store or install units
in corrosive environments or in locations
subject to temperature or humidity extremes
(e.g., attics, garages, rooftops, etc.). Corrosive
conditions and high temperature or humidity
can significantly reduce performance, reliability,
and service life. Always move units in an upright
position. Tilting units on their sides may cause
equipment damage.
Equipment should be stored in its shipping carton in a
clean, dry area. Store units in an upright position at all
times. Stack vertical units a maximum of 2 units high. DO
NOT remove equipment from shipping cartons until
equipment is required for installation.
Unit Protection
Cover units on the job site with either shipping cartons,
vinyl film, or an equivalent protective covering. Cap the
open ends of pipes stored on the job site. In areas where
painting, plastering, or spraying has not been completed,
all due precautions must be taken to avoid physical
damage to the units and contamination by foreign
material. Physical damage and contamination may
prevent proper start-up and may result in costly
equipment cleanup.
Examine all pipes, fittings, and valves before installing
any of the system components. Remove any dirt or trash
found in or on these components.
Page 2