1
Download ASTi Telestra Technical data
Transcript
DOC-01-TELAS-CRG-4 ASTi ACE Studio Components Reference Guide Rev.M 15.1. ColocatedBeacon Control Inputs Summary: The ColocatedBeacon component creates the audio to simulate Colocated VOR and TACAN transmitters. Morse Identifier tones are generated for both transmitters. Ident Interval TACAN_OutSignal n/a Type Default Value float32 1 TACAN_ Type Frequency float32 VOR ID VOR ID Control Inputs Type Default Value boolean True Default Value 1.0 Description: Provides the frequency (pitch) of the TACAN Morse tone. Units are in Hertz. VOR_OutSignal Enable ident Description: Used to set the delay between words. Units are in seconds. TACAN ID VOR_Count = 2 Default Value Description: The ASCII characters that drive the MorseKeyer. Ident is a special variable Type which is defined as 4 ASCII characters concatenated together. A HostIn component must be used to drive this parameter. Description: Co-located VOR and TACAN transmitters present a special case when simulating navigational aides. Both transmitters will produce a Morse Identifier that will be constantly broadcast over the air, but the IDs are broadcast in sequence. As a result, the ColocatedBeacon component can be thought of as two separate Morse Keyers which are designed to never play at the same time. The basic timing can be seen in the picture below. Type TACAN_ Gain Type Default Value float32 1.0 Description: Scales the strength of the generated tone of the TACAN output signal. Description: When True ColocatedBeacon is enabled. 180 Copyright © 2014 Advanced Simulation Technology inc.
