Download Seiko LP-1030-MF User`s guide

Command list
HP-GL,HP-GL/2 Device Control Command List
Symbols in the following table denote as follows:
™ : Denotes the command supported by this plotter.
: Denotes that only part of the command function is supported by this plotter.
× : Denotes the command not supported by this plotter.
If a command not supported by this plotter is received, that command is ignored.
If a command not listed in the following table is received, the command error occurs.
Command
Function
Support
ESC.(
ESC.Y
Plotter ON instruction
ESC.)
ESC.Z
Plotter OFF instruction
ESC.@
Plotter configuration set instruction
× (1)
ESC.A
Plotter model number output instruction
× (1)
ESC.B
Buffer space output instruction
× (1)
ESC.E
Advanced error number output instruction
× (1)
ESC.H
Handshake mode 1 set instruction
× (1)
ESC.I
Handshake mode 2 set instruction
× (1)
ESC.J
Device control instruction abort instruction
× (1)
ESC.K
Plotting abort instruction
× (1)
ESC.L
Logical I/O buffer size output instruction
× (1)
ESC.M
Output set instruction
× (1)
ESC.N
Output mode, handshake mode advanced set
instruction
× (1)
ESC.O
Advanced status output instruction
× (1)
ESC.P
Handshake mode standard set instruction
× (1)
ESC.Q
Monitor mode set instruction
× (1)
ESC.R
Reset instruction
× (1)
ESC.S
Buffer size output instruction
× (1)
ESC T
Buffer size set instruction
× (1)
ESC.U
End of flash buffer
× (1)
(1) Because serial communication is not supported.
(2) Only the binary raster data is effective. Vector data and multi-value raster data are effective only
in the color overlap mode.
(3) The fonts of font number specified by the AD or SD command are plotted with the fonts of the font
number specified by the CS command shown in the following table.
(4) Recognized as EOF.
Appendix-22