Download Datalogic POWERSCAN PBT7100 guide Programming instructions

Interface Related Features
RS-232 Interface Features — cont.
ACK NAK Retry Count
START/END
MODE
BAR CODE
This feature sets the number of times for the scanner
to retry a label transmission under a retry condition.
000 = No retry
001 - 254 = Retry for the specified number of times
255 = Retry forever
To configure this feature, scan the “START/END” bar
code above to place the unit in Programming Mode,
then the “Set ACK NAK Retry Count,” followed by the
three digits (zero padded) from the Alphanumeric
table in Appendix C, Alpha-Numeric Pad representing your desired retry count. Exit programming
mode by scanning the “START/END” bar code
above.
DEFAULT SETTING FOR THIS FEATURE: 003
Set ACK
Nak Retry
Count
3-28
PowerScan® 7000BT SRI