Download Cooper Security M2000 User`s guide

Transcript
Engineering Manual
Engineer Menu 1-8
Option 1-8-2: Setting the Ward Group Exit Mode
Eng 1 Menu 8
Group Options
[
Group Options
Assign Groups
1. SELECT "EXIT
MODES" OPTION
1
|
Group Options
Exit Modes
2
X
[
2. SELECT THE
GROUP
Exit For Group 1
Timed Exit
e.g. |
Exit For Group 2
Timed Exit
To select the group:
Press | or ¬ to scroll, or
Press the hot key (e.g. 2)
[
3. SELECT SETTING
MODE
Exit For Group 2
> Timed Exit
e.g. |
Exit For Group 2
> Instant Set
[
To select setting mode:
Press | or ¬ to scroll, or
Press the hot key (1 to 7)
Press [ to save changes
This option is relevant only when a user sets wards through a ward group. The option specifies
the exit mode for the wards in the selected ward group. You can specify a different exit mode
for each ward group. When a ward group is set, the mode you select here is used instead of the
modes selected in option 1-6 (page 76).
In addition to the options documented from page 76, the following option is also available:
7 – Silent Set
Selecting this option will cause the wards in the ward group to set silently.
) Assigning the Access attribute (page 28) to walk-through zones prevents "zone triggered"
sounds from occurring during the exit or entry procedure
Example
Assume the following:
If ward 1 is set as "Timed Exit" in option 1-6, and
ward 2 is set as "Instant Set" in option 1-6, and
ward group 1 (which contains wards 1 and 2) is set to "Exit Terminate" in option 1-8-2,
Then:
81