Download Cooper Security M2000 User`s guide
Transcript
Engineering Manual Engineer Menu 1-8 Option 1-8-2: Setting the Ward Group Exit Mode Eng 1 Menu 8 Group Options [ Group Options Assign Groups 1. SELECT "EXIT MODES" OPTION 1 | Group Options Exit Modes 2 X [ 2. SELECT THE GROUP Exit For Group 1 Timed Exit e.g. | Exit For Group 2 Timed Exit To select the group: Press | or ¬ to scroll, or Press the hot key (e.g. 2) [ 3. SELECT SETTING MODE Exit For Group 2 > Timed Exit e.g. | Exit For Group 2 > Instant Set [ To select setting mode: Press | or ¬ to scroll, or Press the hot key (1 to 7) Press [ to save changes This option is relevant only when a user sets wards through a ward group. The option specifies the exit mode for the wards in the selected ward group. You can specify a different exit mode for each ward group. When a ward group is set, the mode you select here is used instead of the modes selected in option 1-6 (page 76). In addition to the options documented from page 76, the following option is also available: 7 – Silent Set Selecting this option will cause the wards in the ward group to set silently. ) Assigning the Access attribute (page 28) to walk-through zones prevents "zone triggered" sounds from occurring during the exit or entry procedure Example Assume the following: If ward 1 is set as "Timed Exit" in option 1-6, and ward 2 is set as "Instant Set" in option 1-6, and ward group 1 (which contains wards 1 and 2) is set to "Exit Terminate" in option 1-8-2, Then: 81